CadTools and xTurn (Vehicle Turning Software) Forum

CadTools General Category => CadTools General => Topic started by: Kenan on September 29, 2010, 08:52:55 AM

Title: Annotation of crossection slopes
Post by: Kenan on September 29, 2010, 08:52:55 AM

I use this command a lot, but it has fixed percentage precision, so it's always 2 decimals. This is "too much" for me since I have slopes from Mx in one decimal precision and use Cadtools to add some that software missed. Is it possible to make this precision optional Lars?

Title: Re: Annotation of crossection slopes
Post by: Lars on September 29, 2010, 11:26:53 AM

Sure, that's no problem.
Is it the "Lines,Cross section/Profile slope (Annotate)" command you are using?

Title: Re: Annotation of crossection slopes
Post by: Kenan on September 30, 2010, 08:40:44 AM

Yes Lars, that's the command I use. 2 decimals is ok for longitudinal profiles but for crossections 1 decimal is what we use. But it would be nice to have that option for precision.
Seems like I find new ways to use Cadtools every day , I was working on another computer without cadtools and it was a nightmare, can't even imagine Autocad without it.;D
Thanks for quick response.

Title: Re: Annotation of crossection slopes
Post by: Lars on September 30, 2010, 11:08:11 AM

ok, that will be included in next update.