CadTools and xTurn (Vehicle Turning Software) Forum

CadTools General Category => CadTools General => Topic started by: marcfreitas on March 05, 2013, 06:30:21 PM

Title: station annotation
Post by: marcfreitas on March 05, 2013, 06:30:21 PM

First I like to say congratulations for your software.
I like to suggest a implementation.
In Brazil we use a different station annotation representation
Exemple: 1+19,580 by "1" represents 20 meters.

In drawing : 1+19,850 , 2+14,150 , 3+4,502 and the stations are 1,2,3...

In the software Annotate format "ssss.sss" is the close representation, but it do 20,40,60... for the stations for
a 20 meters Major interval.
Please, Can you implement this actualization in "Stationing Polyline> Drawing output> Format " ?

Thank you
Marcelo
Sorry for my bad english.

Title: Re: station annotation
Post by: Lars on March 06, 2013, 07:28:20 AM

Hi!

I'm not sure about this. It's a bit tricky and probably a lot of coding.

Title: Re: station annotation
Post by: marcfreitas on March 06, 2013, 01:12:21 PM

Ok. Thank you anyway