CadTools and xTurn (Vehicle Turning Software) Forum

CadTools General Category => CadTools General => Topic started by: MVRAO on August 05, 2014, 09:57:26 AM

Title: Exaggeration option in Annotate Cross Section (Table)
Post by: MVRAO on August 05, 2014, 09:57:26 AM

Sir,

In commands/lines/Annotate Cross Sections (Table) under Cross section properties (in drawing), user can input separately for Horizontal and Vertical scales under exaggeration options. But it is observed that, the input (in decimals) given in Horizontal scale option will get rounded up to integer number when we close the Annotate Cross Section pop up window and reopen it. The same thing will not happen with the Vertical scale option.

Therefore you are requested to solve this bug if possible. For convenience, I am herewith attaching images of Annotate Cross Section pop up window before closing and after reopening it.

Thanks in advance.

M V Rao

Title: Re: Exaggeration option in Annotate Cross Section (Table)
Post by: Lars on August 05, 2014, 10:54:01 PM

Hi! Thanks for your report.

The bug will be corrected in next update.