CadTools and xTurn (Vehicle Turning Software) Forum

CadTools General Category => CadTools General => Topic started by: MVRAO on November 29, 2014, 06:30:00 AM

Title: Cross Section/Profile Slope(Annotate); Req. to add select polyline object option
Post by: MVRAO on November 29, 2014, 06:30:00 AM

Dear Lars,

I used this option recently, it is very handy. But I have to annotate a longitudinal profile (which is a autocad 2d polyline) at 20 m chainage/station interval. As the option is written for picking first and lost point to annotate slope over the line, I manually annotated the whole longitudinal profile at 20 m interval. In addition to the present option, If select polyline object option is added to annotate between vertices; it will be much more handy.

Therefore, I request you to release an update to incorporate this command.

Advance Thanks

M V Rao

Title: Re: Cross Section/Profile Slope(Annotate); Req. to add select polyline object option
Post by: Lars on December 10, 2014, 07:42:54 AM

Can't promise anything but I've made a note on this.