CadTools and xTurn (Vehicle Turning Software) Forum

CadTools General Category => CadTools General => Topic started by: MVRAO on March 11, 2016, 12:55:51 PM

Title: Prefix and Suffix for Stationing command in line
Post by: MVRAO on March 11, 2016, 12:55:51 PM

Dear Lars,

Can you add additional options like for writing Prefixes like Ch. (Chainage) or Sta. (Station) and Suffixes like m(meter) or Km(Kilometer for Stationing Command.

Advance Thanks

M V Rao

Title: Re: Prefix and Suffix for Stationing command in line
Post by: Lars on March 11, 2016, 03:08:48 PM

Hi!

I'll look into that!

/Lars

Title: Re: Prefix and Suffix for Stationing command in line
Post by: Lars on March 12, 2016, 01:11:46 PM

It's in the latest update! (709)

Title: Re: Prefix and Suffix for Stationing command in line
Post by: MVRAO on March 15, 2016, 05:19:45 AM

Thanks a lot for update

Title: Re: Prefix and Suffix for Stationing command in line
Post by: Steve b183 on March 22, 2016, 11:13:38 AM

lars

would it also be possible to control which side of the alignment the chainage text appears

I have 2 parallel alignments so would like the chainages to appear on the respective sides not both on the same side

thanks

steve b

Title: Re: Prefix and Suffix for Stationing command in line
Post by: Lars on March 22, 2016, 01:06:55 PM

I Think you can use the Offset value to get it on desired side.

Title: Re: Prefix and Suffix for Stationing command in line
Post by: Steve b183 on March 22, 2016, 05:36:11 PM

lars

i'm guessing a negative offset will do the trick

wil give that a try