CadTools and xTurn (Vehicle Turning Software) Forum

CadTools General Category => CadTools General => Topic started by: Viach on November 24, 2017, 04:33:55 AM

Title: Create Longitudinal Features
Post by: Viach on November 24, 2017, 04:33:55 AM

When the Create Longitudinal Features command is used, smoothed corners are formed. What needs to be done to ensure that the corners remain intact?(http://)

Title: Re: Create Longitudinal Features
Post by: Lars on November 24, 2017, 06:21:51 PM

Hi,

Reduce interval until you are satisfied. Then you can use Cadtools poly line command "weed" to reduce vertices on straight parts of the feature (by settings tolerance). However there is no need to reduce vertices, it is usefully if you are planning to triangulate dense features and want to increase speed.

/Lars

Title: Re: Create Longitudinal Features
Post by: Viach on September 28, 2020, 05:53:50 PM

Hi!
Projected slope - 70.00%, slope actual - 70.31%. How to me to be?

Title: Re: Create Longitudinal Features
Post by: Lars on September 28, 2020, 09:10:44 PM

Hi,
The resulting slope is based on X and Y components. The resulting slope of your triangle is -70.31%. If you have 2% slope in X direction and 2% in Y direction the resulting slope will be 2,83% ( Sqrt(2²+2²))

/Lars