CadTools and xTurn (Vehicle Turning Software) Forum

CadTools General Category => Civil Corner => Topic started by: phubb1 on October 26, 2021, 12:06:59 PM

Title: Contour annotation
Post by: phubb1 on October 26, 2021, 12:06:59 PM

Hi Lars
When I contour a surface the annotation is not always correct due to the number of decimal places. For example a contour of 70.045 is annotated as 70.04. If I inspect this contour it indicates its Z value to 3 decimal places but in the "contents" box it shows a value to 2 decimal places.
In "Settings" slope mode I have set the decimal pl. for all to 3 but still get contours rounded to 2 decimal places. Also in AutoCAD units I have precision set to 3 decimal places.
Is there a setting I can change to get the contour values to annotate to 3 decimal places ?
Many thanks

Title: Re: Contour annotation
Post by: Lars on October 27, 2021, 06:18:20 AM

Hi,
I Will check this issue

Title: Re: Contour annotation
Post by: Lars on October 27, 2021, 10:00:37 AM

Quote from: Lars on October 27, 2021, 06:18:20 AM

Hi,
I Will check this issue

This will be fixed in next update