CadTools and xTurn (Vehicle Turning Software) Forum
CadTools General Category => CadTools General => Topic started by: tonio_slb on July 27, 2012, 11:25:47 AM
-
hi Lars,
I have suggestions for the surface profile, add a "horizontal exaggeration" and "Set End of alignment to station".
_ Sometimes we must make sheets of 700m, so we manually changed the horizontal scale
_ Station start, end of alignment
regards,
-
Hi!
First you do a stationing on your polyline. Cut the polyline at stations of 700m (0, 700, 1400....). Now you have segments of 700 m.
Create individual profile for every segment and use "set start of alignment to station" to set correct annotation (0, 700, 1400....)
/Lars
-
Hi Lars.
How can I create a horizontal exaggeration for the surface profile?
-
Thank you for updating dear Lars.
-
You'r velcome