CadTools and xTurn (Vehicle Turning Software) Forum

CadTools General Category => CadTools General => Topic started by: MRidout on May 02, 2019, 01:36:19 PM

Title: CadTools and ACAD Lt
Post by: MRidout on May 02, 2019, 01:36:19 PM
Dear Lars,
I stumbled on CadTools yesterday looking for a programme to plot simple long sections, generate earthworks and plot cross sections.
It looks marvellous and just the job.
As I run a perpetual ACAD Lt license, is there anyway for CADtools to run in a standalone mode? or through another program that would mean I could avoid having to start paying a month fee to Autocad?
Any thoughts would be appreciated.
Regards
Mat Ridout in Northern Ireland
Title: Re: CadTools and ACAD Lt
Post by: Lars on May 02, 2019, 08:45:22 PM
Hi,
I'm sorry but CadTools will not be a "standalone" software. As it is right now it needs AutoCAd or ZWCAD and I've no plans for adding support for other CAD software.

/Lars
Title: Re: CadTools and ACAD Lt
Post by: MRidout on May 03, 2019, 11:07:42 AM
Hi,
Thank you. I hadn't come across ZWCAD before. It looks good, and if your program works alongside it then it may well be the way to go for my long sections and cross-sections.
Thank you again.
Mat