CadTools and xTurn (Vehicle Turning Software) Forum

CadTools General Category => CadTools General => Topic started by: gvdpeor on February 19, 2020, 08:46:20 PM

Title: Edit/view surfaces - Delete triangles with centroid inside polygon
Post by: gvdpeor on February 19, 2020, 08:46:20 PM
In order to perform this command is it necessary to plot tins? Sometimes it is very hard to select the trim border under all those tins.
Title: Re: Edit/view surfaces - Delete triangles with centroid inside polygon
Post by: Lars on February 20, 2020, 06:40:05 AM
Yes, this command is often used to create holes in a surface. You can create a polyline, drape it on to the surface and then triangulate all your input data plus your draped polyline (draped line as breakline). The draped polyline clips triangels and makes it possible to delete all triangles inside the polyline.