INSTALLATION ERROR MESSAGE

[phubb]

Hi
My first post !!. I have just installed Cadtools and at the end of the installation I recieved an error message as follows:-
GLJD.tmp Entry Point not found
The procedure entry point_except_handler4_common could not be located in the dynamic link library msvcrt.dll

However cadtools seems to open OK although I have not fully tested.

Could this be a problem??
Thanks

Peter

[Lars]

No, there shouldn't be any problems. This error has been reported before but I've not been able to correct it.

[Kenan]

I always get that error on install, just move on , it will work fine. 

[phubb]

Hi

Yes I can confirm that all seems OK although I haven't had time to evaluate everthing that CadTools offers I would say it looks very comprehensive. The vehicle path analysis looks very interesting too.

Regards
Peter

[Lars]

I'll try to drill down on that error. I'm sure CadTools works ok even after the error, the problem is in the installation probably some call to one of the system files.

[jfrench]

I have the same error message after downloading CADtools, but I cannot actually open the programme.

I am sure to be doing something wrong: any (useful) help would be apprreciated.

[Lars]

Could you please describe whats happening and how you do to start CadTools