CadTools and xTurn (Vehicle Turning Software) Forum

CadTools General Category => Civil Corner => Topic started by: MVRAO on December 23, 2013, 08:33:04 AM

Title: Annotate Cross Sections (table)
Post by: MVRAO on December 23, 2013, 08:33:04 AM

Dear Lars,

When iam using commands>lines>Annotate Cross Section (table), I couldn't get the decimals (in the point#, Offset,Elevation data extration table, attached sreen shot for your reference) more than 3 though i input 6 in Decimals box in table option. But it works if I use paste table option.

If it is possible please update the decimal places precision in the data extraction table also.

Rgds

MVRao

Title: Re: Annotate Cross Sections (table)
Post by: Lars on December 23, 2013, 01:12:58 PM

Hi!

The table in the left part is only for a "Preview" of selected points. As you write, the number of decimals will be correct when you annotate the table.

Why would you like to have more decimals in the table?

/Lars

Title: Annotate Cross Sections (table)
Post by: MVRAO on December 24, 2013, 07:04:33 AM

Dear Lars,

I extensively use this tools for preparing Vertical Intersection Points (VIPs) in road vertical alignment fixation.

I just copy the extracted data from the preview portion and append vertical curve length for preparing input file for MXROAD software.

Rgds

M V Rao

Title: Re: Annotate Cross Sections (table)
Post by: Lars on December 24, 2013, 08:57:56 AM

ok! I get it.

You will have a Grid Decimal setting in next update (after Christmas and before New Year)

/Lars

Title: Annotate Cross Sections (table)
Post by: MVRAO on December 26, 2013, 04:25:05 PM

Thank You very Lars for update.