CadTools and xTurn (Vehicle Turning Software) Forum

CadTools General Category => CadTools Tips and Tricks => Topic started by: aldebaran on May 31, 2015, 05:14:33 PM

Title: How to convert splines to polylines
Post by: aldebaran on May 31, 2015, 05:14:33 PM

I have a drawing  of splines (contours)
how can convert them to polylines for surface command
I use Autocad 2007
thank you

Title: Re: How to convert splines to polylines
Post by: Lars on June 01, 2015, 12:33:07 AM

Hi!

If you have created them from CadTools and then used PEDIT for spline you can used PEDIT again and Decurve back to a polyline.

Otherwise you can use SPLINEDIT to convert it to a Polyline.