CadTools and xTurn (Vehicle Turning Software) Forum

CadTools General Category => CadTools Tips and Tricks => Topic started by: ish0000 on January 23, 2019, 04:23:26 PM

Title: Annotate cross section (help)
Post by: ish0000 on January 23, 2019, 04:23:26 PM

Dear sir,
i need your help

from command lines-> Annotate cross section.

i do not need data in table format.

plz see attach image.

i need data in horizontal & vertical format .

any tips & trick.
plz share

Title: Re: Annotate cross section (help)
Post by: Lars on January 23, 2019, 05:41:13 PM

Use "Drafting, Profile/Cross-Section Note" to annotate Elevation and offset from center point.

Title: Re: Annotate cross section (help)
Post by: ish0000 on January 24, 2019, 05:43:37 AM

thanks sir, for your good reply.
this cad tools is wonderful for draftsman .
i am become fan..

great tools

offset   elevation            i need it  vertically  below the cross section line.  like i upload the image above.

Title: Re: Annotate cross section (help)
Post by: ish0000 on January 27, 2019, 09:36:04 AM

I found under profile /cross section note
for write text vertically  (offset v/h) option.

but u need to point for annotate one by one.
It is possible to select all at time and get text value of point or pline..

Thanks

Title: Re: Annotate cross section (help)
Post by: Lars on January 27, 2019, 12:06:26 PM

I'm sorry, but that's not possible

Title: Re: Annotate cross section (help)
Post by: ish0000 on January 27, 2019, 03:15:52 PM

ohh, break my heart.

i have a lisp program for polyline of cross section and profile to get text value in form of offset and elevation.
i attched the lisp.

if it suitable to add in cad tool that will be good.

thanks.