« previous next »
Pages: [1]   Go Down

Author Topic: Annotate Cross Sections (table)  (Read 6614 times)

MVRAO

  • Newbie
  • *
  • Posts: 21
  • MVRAO
Annotate Cross Sections (table)
« on: December 23, 2013, 08:33:04 AM »
Dear Lars,

When iam using commands>lines>Annotate Cross Section (table), I couldn't get the decimals (in the point#, Offset,Elevation data extration table, attached sreen shot for your reference) more than 3 though i input 6 in Decimals box in table option. But it works if I use paste table option.

If it is possible please update the decimal places precision in the data extraction table also.

Rgds

MVRao
Logged

Lars

  • Administrator
  • Hero Member
  • *****
  • Posts: 643
Re: Annotate Cross Sections (table)
« Reply #1 on: December 23, 2013, 01:12:58 PM »
Hi!

The table in the left part is only for a "Preview" of selected points. As you write, the number of decimals will be correct when you annotate the table.

Why would you like to have more decimals in the table?

/Lars
Logged

MVRAO

  • Newbie
  • *
  • Posts: 21
  • MVRAO
Annotate Cross Sections (table)
« Reply #2 on: December 24, 2013, 07:04:33 AM »
Dear Lars,

I extensively use this tools for preparing Vertical Intersection Points (VIPs) in road vertical alignment fixation.

I just copy the extracted data from the preview portion and append vertical curve length for preparing input file for MXROAD software.

Rgds

M V Rao
Logged

Lars

  • Administrator
  • Hero Member
  • *****
  • Posts: 643
Re: Annotate Cross Sections (table)
« Reply #3 on: December 24, 2013, 08:57:56 AM »
ok! I get it.

You will have a Grid Decimal setting in next update (after Christmas and before New Year)

/Lars
Logged

MVRAO

  • Newbie
  • *
  • Posts: 21
  • MVRAO
Annotate Cross Sections (table)
« Reply #4 on: December 26, 2013, 04:25:05 PM »
Thank You very Lars for update.
Logged
Pages: [1]   Go Up
« previous next »