Author Topic: Surface Cross Sections  (Read 153 times)

phubb1

  • Newbie
  • *
  • Posts: 15
Surface Cross Sections
« on: August 25, 2021, 06:38:59 PM »
Hi Lars

May I ask if it would be possible to add a function to plot cross sections with Station 0 at the bottom rather than the top.
I have a highway where the stationing goes up - ( from south to north ) Having the cross section going in the same direction would be very helpful.

Many thanks

Lars

  • Administrator
  • Hero Member
  • *****
  • Posts: 589
Re: Surface Cross Sections
« Reply #1 on: August 25, 2021, 09:37:12 PM »
Hi,

I'm not sure i get this, could yo be more precise. Do you want the cross section set in opposite direction? (start from last section and then continue to the first)

phubb1

  • Newbie
  • *
  • Posts: 15
Re: Surface Cross Sections
« Reply #2 on: August 27, 2021, 03:46:05 PM »
Hi Lars

I hope I can explain.
Usually Station 0 cross section is at the top of a series of sections.
I have an alignment where Station 0 is at the bottom ( to the south of the last Station with chainages increasing in a northerly direction) What I would find helpful if the Cross Section for Station 0 when plotted was at the bottom of the group of sections with the others above.
Like this :-

Station 100     Cross Section 100
Station 80       Cross Section 80
Station 60       Cross Section 60
Station 40       Cross Section 40
Station 20       Cross Section 20
Station 0         Cross Section 0


Regards

Lars

  • Administrator
  • Hero Member
  • *****
  • Posts: 589
Re: Surface Cross Sections
« Reply #3 on: September 05, 2021, 10:01:50 PM »
ok.
I'll see what I can do

Lars

  • Administrator
  • Hero Member
  • *****
  • Posts: 589
Re: Surface Cross Sections
« Reply #4 on: September 12, 2021, 07:40:27 PM »
ok.
I'll see what I can do

Current update 749 include cross-sections in reverse direction.

phubb1

  • Newbie
  • *
  • Posts: 15
Re: Surface Cross Sections
« Reply #5 on: September 28, 2021, 05:17:36 PM »
Hi Lars

Thank you - that will be very helpful.