xTurn (Vehicle Turning Simulations) > IntelliTurn/BricsTurn/MSTurn General

Tags on created paths

(1/1)

Architec:
Hi, Lars.

Is it possible to add a tag with the name of a vehicle on the creation of sweep lines? Sometimes, when I look back at drawings I did a long time ago, I can not recall what type I used in the particular case. Just a simple name, in the beginning, is fine.
And another idea. Is it possible to program module the way so it would create a block with all blocks of sweep lines in it? I mean, when I check "Plot Vehicle", "Swept Paths" and "Envelope", there are basically 3 blocks after simulation. It is fine, but when I have a lot of types I want to simulate on a single spot, it gets messy. If those 3 blocks would be included in one parent block, it would be much easier to differentiate between each simulation. Hope it is possible to do :)

Best luck

Lars:
Hi,

I'll put a note on the top of my todo pile );

/Lars

Navigation

[0] Message Index