Author Topic: cut/fill-create slopes  (Read 86 times)

gugle

  • Newbie
  • *
  • Posts: 4
cut/fill-create slopes
« on: May 20, 2022, 06:57:17 PM »
I  am an occasional and inexperienced user of cadtools. Basically, I need it to create ditches and slopes. Of course, I also need, secondly, to create a longitudinal profile and characteristic sections from this. If I can ask for a short instruction: how to create a slope in that order: I have a bottom line (3Dpl) on level below terrein and I need to create a slope from this level up, (e.g. 1: 3 33%) until to intersect with the terrain. I have terrain triangulation * .tsd and pl3D (on set level) of the pond boundary. How to make an up cut to generate a top slope for such a slope?
If I use this tools the program hangs:



Lars

  • Administrator
  • Hero Member
  • *****
  • Posts: 613
Re: cut/fill-create slopes
« Reply #1 on: May 22, 2022, 09:46:32 AM »
Hi,

Using the settings in the form as it is in the picture you should i.e use a EOP (edge of Pavement) 3D polyline as your guide line.
If the guide line is a pond bottom you can try to set foreslope distance and ditch width to zero, backslope should be 33,3%. Tip, use the preview window while editing values.

The error is probably due using wrong decimal separator (You should use same as Windows use)

/Lars